01Services

What we do, under one roof

Pattern making, casting, machining and inspection happen at the same works in Korangi, Karachi. Pick the service closest to your job, or send us the part and we will tell you what it needs.

01Sand casting

Sand casting, from pattern to poured part

We have been pouring sand castings in Korangi, Karachi since 1989. Patterns, moulding, melting and shake-out all happen at our own works, so a drawing or a single sample part is enough to start.

02Iron castings

Gray iron and SG (ductile) iron castings

The company was founded by a metallurgist, and the iron we pour is a decision we make with you rather than a default. Which of the two your part needs comes down to how it is loaded.

03Machining

Machining castings into finished components

Casting and machining sit under one roof here, which removes the hand-off that usually costs time and accuracy. We also machine parts that were cast elsewhere.

04Reverse engineering

Reverse engineering, from one sample to a new part

When a machine is down and the part is no longer imported, a single sample is enough to start. We have rebuilt parts from worn originals, broken pieces and parts with no drawing at all.

05Aluminium castings

Aluminium castings, in sand or gravity dies

Aluminium is a third of the weight of iron, flows into thin sections and stays pressure-tight when it is cast properly. We pour it both ways: in sand for one-offs and smaller runs, and in gravity dies once a part repeats often enough to justify the tooling.

06Gravity die casting

Gravity die casting for repeat aluminium parts

In gravity die casting the metal is poured into a permanent steel mould rather than a sand one, under gravity alone. The mould is reused thousands of times, so every casting comes out the same, with a smoother surface and tighter dimensions than sand can hold.

07Brass & bronze castings

Brass and bronze castings, machined to size

Copper alloys earn their place where iron and aluminium struggle: running against a steel shaft, or sitting in water and chemicals that would rust an iron part. We pour brass and bronze alongside our iron and aluminium work.

Parts catalogue, 2026

A selection of parts we have cast and machined, with material, process and machining detail for each one. 6.4 MB PDF.

Download the catalogue

Not sure which process your part needs?

Send a drawing or a photo of the part. We will tell you how it should be made, and what it will cost.

Request a quote